Raypak Temp-Tracker Spezifikationen PDF herunterladen (Seite 6)

6 Raypak, Inc.

MAKE SURE YOU HAVE THE RIGHT CONTROL

If you need the TempTracker mod+ to do additional tasks that either are not listed or do not know how to congure them, contact your

local Raypak representative.

INITIAL SETUP

Setting an Initial Program will ease the conguration of the TempTracker mod+ and will give the opportunity to utilize many of the

energy saving features and give more comfortable heat when needed.

The program should consist of the following:

• Selecting the features that your system can utilize,

• Installation: Install the Control, switches and sensors,

• Setting the System Startup,

• Setting the System Settings,

• Setting the Stages

• Adjusting Reset Ratio and Water Offset (In Reset Mode Only)

SELECTING THE SYSTEM FEATURES

The TempTracker mod+ has been designed with Hydronic building heating as the primary purpose. With this in mind, many of the

TempTracker mod+ features can be utilized to ease, enhance and improve your system performance. Some of these features are listed

in this section.

OUTDOOR RESET OR SET POINT

• The TempTracker mod+ can control the System Temperature either by adjusting the calculated temperature according to the Outdoor

Temperature (Outdoor Reset) or by maintaining an adjustable Set Point. The earlier relies on an Outdoor Sensor (supplied with the

control) and achieves better fuel savings in addition to better comfort.

NUMBER OF STAGES

• The TempTracker mod+ can be congured to control up to 4 modulating boilers. It can control up to 16 boiler stages using a maximum

of two TempTracker mod+ Extension Panels

MODULATION MODE

• The TempTracker mod+ stages boilers using parallel modulation. Parallel modulation can modulate several boilers together as a

one large boiler. This is useful for boilers which are more efcient at lower ring points.

MODULATING SIGNAL

• The TempTracker mod+ is designed to accurately control the output from 25% to 100% of modulation for each of these different

types of equipment. One TempTracker mod+ can even control a variety of the above different modulation equipment.

AUTOMATIC ROTATION AMONG BOILERS

• Rotating the rst burner to be activated on a call for output promotes even wear on all burners. The TempTracker mod+ has three

modes of rotation: Manual, Last-ON, or Time automatically rotating every selected time period from every hour to every 60 days.

STANDBY BOILER

• Any boiler can be congured as a Standby boiler. It withholds a specic boiler from being included in the Lead Rotation. However,

the Standby boiler will be red only as a backup when all other stages combined cannot satisfy the demand and after an adjustable

delay period.

SETBACK OR DAY/NIGHT SCHEDULING

Two Setback modes are available for the TempTracker mod+:

• The Day/Night Scheduling provides an adjustable time-based schedule for the Setback.

• The Setback mode uses an external signal to switch the operation of the TempTracker mod+ in and out of setback mode.

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Keine Kommentare

Raypak Temp-Tracker Spezifikationen Seite 6